All MetalShaping

I'm new to the site. I'm currently working on a Dodge A-100 window van that was converted to a pop top camper when it was new, a California company. I've owned it since 1978 and have put many over the road miles on it. Drove it to Texas and back in 2009/2010. It's done a western states loop a number of years ago.

I'm re-engineering the original camper equipment and design. Currently doing the fabrication to install a refer and air/heating system from an 18 wheeler. Part of the process is to vent the refer to the outside to prevent propane combustion from filling the sleeper area. I've got a Pullmax and am researching louver dies needed to cut louvers to the outside. I have the upper Pullmax dies for 2 louver sizes but the lower dies disappeared before I hauled the machine home. Going to build the lower dies. I'm starting that process today.