Introduction
 

I'm a newbie to metal working. My passion is hot rods, and my last ride was a 1938 Dodge. I did almost all the work myself, but one of the things I never tried was to reshape any metal on the car, other than some welding. A few spots on the car were filled with bondo. Luckily there weren't many bad spots.

I had to sell the car a couple years ago, and am getting ready to purchase another car to transform. The Turkey Run is next week, so hopefully I can get my ride there.

I want to be able to do all the metal work myself, but do not have a clue yet on how it's done. I was hoping to learn on this site.

Thanks! Bob

Welcome to allmetalshaping Bob.

David