Fng
 

I have a 1957 Chevy Cameo that I'm restoring and am interested in learning about the basics of metal shaping.

I am a Navy Pilot and enjoy a hobby of hotrodding and flying GA airplanes in my spare time.

Welcome this is the right site to learn. Ive done 2 Cameos so might be able to give some technical help.

Welcome to AllMetalShaping Kelly and thanks for your service. I have huge admiration for anyone who can land an airplane on a carrier. Metalshaping should be a piece of cake by comparison.

If you're a North Island guy, you should have been here last week. Check out the Fallbrook thread in the events section. For a newb like myself, it was a very eye opening experience and not to be missed. Mike ( and friends ) unlocked many metal mysteries and there were opportunities to network with others, try new tools, ect.

Hello Kelly and welcome to the forum and thank you for your service!;):)

There is a get together in Santa Cruz at the end of October. Hope you can make it.

Jere