All MetalShaping - New Member From NW PA

Hey Guys

I have a 68 F250 4x4 I am restoring so needless to say I have some sheet metal to replace. Driveline is gone over and put back together with new bits so now its time for the metalwork. I have a Lincoln 180 on gas to weld up the body as well as the usual garage tools but I'm a beginer when it comes to bumping metal so I do not have any body tools. I have used the Lincoln for frame and support items but not light gauge body material so I will be looking for advice on techniques to make this a little easier.

Thanks,
CStoyer