All MetalShaping - sheet metal challenge

All MetalShaping (https://allmetalshaping.com/index.php)

- Introductions (https://allmetalshaping.com/forumdisplay.php?f=7)

- - sheet metal challenge (https://allmetalshaping.com/showthread.php?t=19953)

fisa	08-27-2020 05:22 AM

sheet metal challenge

i am asif iqbal recently work on motercycle fender die development ..and stuck at hemming process of edge around the fender .looking solution ,advice or expert opinion.

regards

asif

cliffrod

08-27-2020 01:24 PM

Welcome to the forum, Asif. It's always good to have another motorcycle person here.

All times are GMT -5. The time now is 12:23 PM.