New from South Carolina
 

I have been building cars since i was a boy helping my Dad. I have built Mustangs, Cadys, Corvette,and more recently completed a 1929 DODGE Brothers that belonged to my Dad. I recently purchased a 1964 FC-150 and was surprised at the lack of metal repair panels that are available. Long story short as i was searching I happened upon this page where a guy was writing about building repair panels for an FC. So that is the reason i signed up. Thanks.

Hi David
Welcome to Allmetalshaping!
Hope you find the site helpful

Good to see a new member from SC- Welcome to the forum, David.