New member from Sweden.
 

Hi! I´m Mats from sweden. I´m here looking for tips on how to use pullmax machines.
I have had a p2 for many years but never really understood its
capabilitys.

I´m looking forward to read what you do with these machines in the us
since they are so rarely used here.

Mats, welcome and thanks for the introduction. Hope you find the site helpful and enjoyable. Ask questions if you have them about the Pullmax. Thanks for joining us.

HI Mats and welcome to the forum, there is a book out by Fay Buttler that will show you all you need to know about pullmax
Peter

Hi and welcome Mats,:)
If you do a search on "pullmax" you should have enough to read for a week:D
Here I did one for you.

http://allmetalshaping.com/search.php?searchid=797323

Have fun reading

Hi and welcome Mats:)

Pullmax is one of the most useful machines for a really low cost :D
Sure you will find all you need to know and maybe even more on this site about metalshaping....

Thanks!
 

Thanks for welcoming me!

I allready found a lot of inspiration here.

Think I will order that Fay butler book too, Thanks for the tip.