Hi from VA
 

Hi there,

I read a few of the intros and it looks like most of you are far more experienced than me, but I'm here to learn. I have a small (just me) powder coating and metal fabrication shop. I do a lot of cnc plasma cutting for signs and off road parts. I am currently restoring a 50 GMC truck that has been occupying my driveway for a few years. This is more precise hammer and dolly work than I usually do, but I really enjoy it.

I also make knives. You can check the knives out on my facebook page:

http://www.facebook.com/pages/Drylab...58582367526515

If that link doesn't work you can search "Drylab Fabrication" on facebook.

Aaron, welcome and thanks for the introduction. Hope you enjoy the site and find it useful. Thanks for joining us.

Hi Aaron and welcome!:D

HI Aaron welcome to the forum
Peter

Hello Aaron,

I get into your neighborhood every once in a while.. When riding my motorcycle.... also, Captain Kirk isn't too far from you in Warrenton...
I guess you are a member of NVKCC.. I used to be a member a long time ago...
Welcome aboard....

Aaron, welcome to allmetalshaping, you obviously have hand skills so its a case of learning techniques and then practicing.

David