Introduction
 

Hello all, I am new to all this ether chat so I am afraid that I am a little less than proficient at present.

I have been metal bashing for some time - but like my fleet I am rusty -so I have need to re-learn and recall as it has been a long, long time since I last touched the proper tools during my apprenticeship.

I hail from a wet and cold Wales and have a half finished Triumph wing to sort using only hand tools so when it warms up a little I shall go back to making some noise.

Need some assistance with finding decent tools - I have to do this carefully as I am not a millionaire!

HI Colin
Welcome to the forum
Peter

Thanks Peter
 

That was a quick reply had a look at some of the vids and it looks like I am in the right place.

Tidy!

Colin
there is a lot more good tradesmen on the site with good ideas and good skills
Peter

Hi Colin and welcome !:)

Monster, monster
 

What is the engine in the 12c beast!

looks like it feeds on small children...Or big ones.:eek:

Thanks for the welcome.

Hi Colin welcome to the site. Its wet and cold here in Essex as well so you are not alone.

David