Intro from WA
 

Not sure what happened to my first intro, but here goes again. I'm Josh from Camas, WA - not too far from Portland, OR. I was linked to AMS from another forum and after a few minutes of reading one thread I was hooked and realized I needed to join. I've done minimal shaping in the past (dishing stumps), but don't have any wheel or bag experience. Only tools I have that could be considered metal shaping are the hammers and anvil I have from a previous venture into bladesmithing. I've always wanted an eWheel and am hoping to find the knowledge and motivation to finally buy or build one from everyone here.

Cheers,

Josh

welcome aboard

HI Josh
Welcome to the forum
Peter

Hi Josh and welcome!:)

Thanks all for the welcome messages. Looking forward to start obsessing over all the threads I can now see. For some reason, I'm much happier about this than my wife :D