| Cheapthrillsfabricator |
09-13-2013 11:17 PM |
Hello all, new to the site
Hello everyone, I'm Jeremy new to this site and hoping to learn a few tips and tricks to hone my talent. I've am a complete novice in the shaping of sheetmetal. I recently bought a 1938 olds businessman coupe with substantial rot on the lowest 5-8". With that being said repair panels if found are quite costly. So I'm nearly finished building an english wheel and am thinking about investing in a shrinker stretcher. So I will appreciate any and all advice and constructive criticism.
|
