New here from Ontario Canada
 

Hey guys I am a new member here from the great white. I have dabbled in metal fab and am here to learn from the best. I currently have a shrinker, stretcher combo, bead roller modifed and powered by me, sheet metal brake, slip roll, shear and lots of homemade other goodies. Just looking for some more skills to utilize over the long codl winter coming.

Hello Bob,

welcome to the forum. Sounds like you have a good few machines so you must be pretty into this stuff already. Knowing where to put the welded joints and techniques to keep distortion to a minimum are something I consider key to getting good results in the finished panels. Have a look around the site and ask questions if you have any, there is always someone who will have an answer.


David

Hi Bob and welcome!:)

Hi Bob welcome to the forum
Peter

Hi Bob! Welcome to AllMetalShaping from Niagara Falls, ON :) Were abouts in Ontario are you located?