[kaharshs]

Hello,

I go by Kyle. I have been a Aircraft sheet metal worker for the past 12 years. I am currently changing careers and moving over to the machining and welding side of aircraft maintenance. I have my airframe license and am working on getting my powerplant license. I have also been an automotive mechanic and fabricator for many years. I perform a good amount of sheet metal repairs on older vehicles. My personal project is a 1973 Plymouth Duster that I made into a demon clone. I have installed new quarters and a taillight panel. I made my own tubs, trunk floor, 4 link, shortened 8.8 rearend. The car also has the a/c, engine, transmission, steering column, fuel system, instrument cluster, and electrical system from a 1994 2wd dodge ram. I have a few degrees and i am almost finished with my bachelors in business. I also recently purchased a 1960's arco gas station on a half acre. I plan on opening my own metal fabrication business.