New Member From NW PA
Hey Guys
I have a 68 F250 4x4 I am restoring so needless to say I have some sheet metal to replace. Driveline is gone over and put back together with new bits so now its time for the metalwork. I have a Lincoln 180 on gas to weld up the body as well as the usual garage tools but I'm a beginer when it comes to bumping metal so I do not have any body tools. I have used the Lincoln for frame and support items but not light gauge body material so I will be looking for advice on techniques to make this a little easier.
Thanks,
CStoyer
__________________
Curtis
1968 Ford F-250 4x4
447 FE Motor SCAT, Diamond, Comp, Jesel, Holley, Canton, Edelbrock, Hooker, Flow Master
New Process 435 4 Spd
Dana/Spicer 24 Transfer Case
Dana 44 12 Bolt Closed knuckle 3500# Front Axle
Dana 70 Rear Axle Detroit Locker
|