The issue I think that you are going to have is that the X rails look to be 75mm x 50mm (2X3 for our american cousins) is that you are going to end up with a pretty high tunnel through the car going by the picture showing how low the car is sitting with the wheel, in the wheel arch, as the height of the pinion on the diff looks like it will be higher than the floor at the rear, also with the car sitting that low you won't be able to run the exhust under the car, so it is going to have to go through the rails, so if are running a 2 1/2" (63.5mm) exhust pipe there is not much room left in the x pieces to put holes through them for the pipes, and have clearance around them, if there was it would make them very weak.
I am happy to come look and discuss the options to make it work
__________________
Kind Regards
Toprodz
Peter
|