[Fpicabia]

Hi all,

I'm relatively new to metal forming/shaping. I have reshaped a few steel motorcycle gas tanks in the past but am going to brave some aluminum ones from the ground up. I am hoping to glean as much as I can from experienced sources, i.e. Here. I was referred to you by a metal fab guy here in Brooklyn that I respect a great deal and hope that through research, digging and asking questions I'll find the info I need. Pretty excited about the prospect of this.

Hopefully I will soon be able to share some tips and suggestions.

Thanks,
Jeff Taylor

Be well, do good and do it often.