Hi new to site and live just out side greensboro. I was referred to site by fellow at yellow bullet. I was lookinf ro idea on best way to approach a rear body for FED Im building. The closest thing to it would be Adam Sorokins new Nostalgia top fueler
.
I have build few raccars and ran alky funny and dragster for about ten years. Our funnycar would be better known
We ran it thought eastern half US.
Like said point of vist to site is to see if can get some ideas how to best approach b uilding the rear section. I have few and a little fabtrication experiance. The multiple contours and trying to make it one piece with as few welds as possible have made this a good test to say the least. Figure maybe few here might be helpful and your being local doesn't hurt well same state. ANY IDEAS?