Thread
:
Hammer form advice please
View Single Post
#
2
02-06-2019, 06:49 AM
Jaroslav
MetalShaper of the Month April 2020, September 2021, November 2022
Join Date: Dec 2012
Location: Czech Republic
Posts: 2,611
Sheet metall is not rubber.
Great violence. You pushed the sheet much where it had to burst. You have to start to beat from top to bottom and gradually vertical to this place. It would be good to warm up and do the same steps.
__________________
Jaroslav
Jaroslav
View Public Profile
Send a private message to Jaroslav
Find all posts by Jaroslav