Thread: P9 tooling
View Single Post
  #2  
Old 05-22-2019, 03:42 AM
metal manny metal manny is offline
Member
 
Join Date: Aug 2011
Location: Johannesburg, South Africa
Posts: 509
Default

Pullmax adaptor.pdfHi Stu.
Not certain how your P9 tool post is configured, but on the P-21 model, the tool holder can be inserted with the offset inside or outside the throat. Using this ability, I have fabricated a spacer plate to centre the offset tool holder.
Bearing in mind that original accessories for these machines cost an arm and a leg at best, with this method (if possible in your case) you'll have the best of both worlds!
The attached pic illustrates the principle...
__________________
Manny

Remember that the best of men, are only men at best.

Last edited by route56wingnut; 05-22-2019 at 04:39 AM.
Reply With Quote