View Single Post
  #7  
Old 03-11-2019, 04:33 AM
Antoine_P Antoine_P is offline
MetalShaper of the Month August 2020, Sept 2022
 
Join Date: Feb 2019
Location: Stuttgart, Germany
Posts: 294
Default

Thanks a lot Marcus!
I am trying to do my best on it, doesn't want to do a show car but a (really) nice driver
To answer your question: I replaced the entire fuel line with a new one that I tested. All the tubes that I repaired as seen on the pic are only for cables like gas, clutch, heater,..

So, let's continue the topic

Now that the bottom was ready, time to turn the frame and do the same, clean and primed:




And then I started to adjust the half pan:




Used the future heater channel to adjust:


And then after cleaning/primering the half pan, it was time to weld them:




I also finished to clean/put in primer the back end:






To be continued

Antoine
__________________
Antoine Puygranier
Resurrecting a 60 ghia:
http://www.allmetalshaping.com/showthread.php?t=18852

Fixing a 914:
https://allmetalshaping.com/showthread.php?t=20624
Reply With Quote