View Single Post
  #22  
Old 09-05-2020, 03:45 AM
123pugsy's Avatar
123pugsy 123pugsy is offline
MetalShaper of the Month Dec. 2019, Feb. 2022
 
Join Date: May 2009
Location: Markham,ON
Posts: 2,165
Default

Never seen one before. I've just read about it on a couple of forums.


From what I remember reading:

The key is to put crown into a panel evenly as the first part. Maybe an inch high. The crown should be the same both ways with the four corners touching the table. Then, wheel the sheet perfectly flat again.
__________________
Pugsy

my project:
http://www.allmetalshaping.com/showthread.php?t=154
Reply With Quote