View Single Post
  #5  
Old 08-01-2020, 06:04 PM
blue62 blue62 is online now
Member
 
Join Date: Aug 2016
Location: Woodland Wa.
Posts: 182
Default

First thing I would do is go to youtube.
Search for Peter Tommasini.
View his video: light discussion about full radius anvils vs flats.
View everything he does.

Anvils with flats have a very narrow flat just in the center of the anvil.
My guess is that the Eastwood anvils have flats but that is just a guess on my part. Perhaps someone here on the forum will jump in and confirm one way or the other.

Then try to find some information on a wheeling exercise called shape in shape out.

Also shrinking the two edges has probably locked a certain amount of shape into the panel.

Get another piece about a foot square. mark all four edges an inch in from the edge.
wheel top to bottom from on side to the other.
Turn the panel 90 degrees and top to bottom from one side to the other again.
Go slow keep your tracks close together and stay off your one inch margin.
I repeat stay off the edges.
you should begin to see equal radius in both directions.

Perhaps purchase a book titled:

Learning the English Wheel
By William H. Longyard
published by Wolfgang publications Inc.

Bill put some good information in that book.
__________________
Dave Bradbury

Last edited by blue62; 08-01-2020 at 06:18 PM.
Reply With Quote