Thread: Mag drill
View Single Post
Old 02-25-2021, 09:44 PM
boltboy49 boltboy49 is offline
Join Date: Feb 2021
Location: normal, Il
Posts: 19

On my first table I went with 1/2-13 holes on 4" centers, this proved to be too far apart. I usually use table clamps like one would use on a milling machine. On my second table I measured the slot of my longest hold down clamps and decided on 3" on center. This way any spot on the table can be reached by at least two holes. Here are some pictures of my table in use.

Reply With Quote