|
|
|
#1
01-15-2014, 11:58 PM
|
|||
|
|||
Happy to be here
Hello all, my name is Kerry & I now reside back in Australia after living in CA from 96 - 07. I have been a panelbeater (body man for all you US folk) since 1967, so probably now classified as an old man.
 I was a teacher of panelbeating ( 1982 - 1995 ) before following my dreams & moving to the US. I am now back home, but still playing with all things metal. My areas of expertise are the common metals found in older cars including steel, aluminium (I know it's wrong spelling to you guys), brass, copper & die cast (pot metal). I discovered this site today & joined immediately. I am an admin for another forum here in Australia called MustangTech. Basically a bunch of people helping one another, very similar to what appears to happen here. I hope to increase my knowledge by being here & share what I have learned over the years .....  Kerry 
|
|
#2
01-16-2014, 05:19 AM
|
|||
|
|||
|
Hi Kerry welcome to the forum and back to OZ
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
01-16-2014, 01:07 PM
|
||||
|
||||
|
Welcome to the site Kerry.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer. Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#5
01-16-2014, 06:33 PM
|
|||
|
|||
|
Welcome to the forum Kerry.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
