|
|
|
#1
09-08-2015, 12:02 PM
|
|||
|
|||
New from central california
Hello everyone, looking to learn your techniques on shaping steel. I've done small patch panels for fenders and quarter panels before but want to improve the way I have been doing them and learn better ways of making patch panels. I currently have a 55 German Ford Taunas project that I'll have to make repair panels for rust repair and as far as I can tell nobody makes any so I need to improve my work before making lower portions of the fenders and other patch panels.
Jay 
|
|
#2
09-09-2015, 12:30 PM
|
||||
|
||||
|
Hello Jay and welcome to the forum from California.
Just ask your questions and they will be answered. Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
