|
|
|
#1
10-23-2015, 09:51 PM
|
|||
|
|||
Greetings
Hello I am new here, and you all know I need to say. A little about myself.
I have decided to try and join so I could have a chance to see others opinions on metal shaping. I am looking to build a reciprocating hammer with similar properties and uses as the pull max machines. Would be great to collaborate with other people on this subject. So the way I found the site was through Instagram. Someone had posted about the site there. Thanks for your consideration of my membership here. Jason. :-) 
|
|
#2
10-24-2015, 11:21 AM
|
||||
|
||||
|
Hello Jason and welcome to the forum.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
10-24-2015, 07:39 PM
|
|||
|
|||
|
Hi Jason welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
