|
|
|
#1
10-24-2015, 02:10 AM
|
|||
|
|||
G'day from W.A.
Greetings my name is Geoff, I am from Western Australia, I have slowly been building a 37 chevy pickup hotrod. In the process I have ended up building an English Wheel, Shop Dog inspired reciprocating machine, Shop press, small bender, powered bead roller and well you get the picture, sheet metal doesn't bend itself does it?
Anyway I have just got access to a Trumpf cn701 copy nibbler that has been sitting idle at my local metal fabricator, they have had it for ten years and used it once. I have cleaned off the 10 year old inch thick dust, refilled the empty sump for the crank and figured out the speed, stroke length and tool limit controls. But unfortunately it only has a couple of tools and I am on quest to make louvers. So, I am here to find pullmax/trumpf louver die via angle grinder and welder guidance.
__________________
geoff 
|
|
#2
10-24-2015, 06:05 AM
|
|||
|
|||
|
Good morning Geoff, welcome to the forum. Make your self at home, visit often and post when you can.
__________________
Will
|
|
#3
10-24-2015, 11:18 AM
|
||||
|
||||
|
Hello Geoff and welcome.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#4
10-24-2015, 07:39 PM
|
|||
|
|||
|
Hi Geoff welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
