|
|
|
#1
11-19-2015, 01:46 PM
|
|||
|
|||
New to the forum from South Louisiana
You can see some of my work at www.psjuneau.com
I make a good bit of furniture but I mostly make smaller wall hangings. I spent this week making trophys for a "best of" award event. All of my work is in aluminum, however my dad works in the same shop and he only works in steel. My harbor freight plaishing hammer that I use several hours a day broke off its hammer head yesterday and the replacement that I got yesterday afternoon mushroomed immediately and seized in the barrel in under an hour of use. The old one was 3-4 years old with thousands of hours on it.
__________________
Andre Juneau 
|
|
#2
11-19-2015, 03:14 PM
|
||||
|
||||
|
Hello Andre and welcome to the forum.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
11-19-2015, 06:30 PM
|
|||
|
|||
|
Hi Andre welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
