|
|
|
#1
12-11-2015, 06:25 PM
|
|||
|
|||
Hello everyone again
Hey,
My last post lacked some info, I'm John I'm from Boston MA I'm a metal fabricator and have been for a while now. I build motorcycles for fun and have a small shop in Worcester to work on projects. I'm about to start a 51 panhead build I'm looking forward to learning as much as I can about metal shaping, the proper tools and technics I'll need to take my sheet metal game to the next level. I've modified gas tanks and fenders and hope to post some pictures of past and future projects I've worked on. Thank you very much- John
__________________
John Repetto Mansfield, MA 
|
|
#2
12-11-2015, 09:39 PM
|
||||
|
||||
|
Hey John welcome back. Lets see some photos.
 Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
12-13-2015, 07:03 AM
|
|||
|
|||
|
Hi Mansfield welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
