|
|
|
#1
05-29-2016, 03:23 AM
|
|||
|
|||
New Member from New Zealand
Hi everyone my names Steve Brown i am 24, Im from a small part of the world called New Zealand.
I am a Builder of New Houses I currently own 2004 ford courier that im working on its on air suspension its been body dropped and has a 302 windsor out of a mustang. Im sure every one on here can relate to this, At the moment i have one concave panel to make under the hood so i can fit the intake on motor. O i better make an english wheel this is when i found all metal shaping. I have ordered my contact flat anvils and top wheel from Adam from the uk on ebay. just need to get started on my frame and adjuster. In my other spare time i enjoy to travel, surf, ski, wakeboard and paddle board. Looking forward to have full access to the forum so much good information. Thanks Steve
__________________
Steve Brown 
|
|
#2
05-29-2016, 07:22 AM
|
|||
|
|||
|
Hi Steve welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
05-30-2016, 03:34 PM
|
||||
|
||||
|
Hello Jarrad and welcome.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
