|
|
|
#1
03-16-2011, 03:26 PM
|
|||
|
|||
New Member
I have been involved in all aspects of metal fabrication during my career in the military. Currently supervising a machine and welding shop used for training. Hoping to pick up some information on designing and building some sheet metal fabrication equipment for my home shop. Looks like lots of interesting topics on this forum.
Thanks 
__________________
D. Madole Dallas Center, IA 
|
|
#2
03-16-2011, 04:12 PM
|
||||
|
||||
|
Welcome to Allmetalshaping D. Madole!
lots and lots of information on building just about any machine for your garage/shop. Just use the search link set back and enjoy
__________________
Rick Scott The second mouse gets the cheese!
|
|
#3
03-16-2011, 05:15 PM
|
||||
|
||||
|
D. Madole, welcome to the site and thanks for the introduction. Thanks for your service helping to keep us free. Lot of information here to help you with you shop. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
 |
|
|
Linear Mode
