|
|
|
#1
06-10-2011, 10:15 PM
|
|||
|
|||
New from So-Cal
Hi everyone,
I haven't laid a bead down since high school but I'm finally getting back into restoring my 60 Oldsmobile and want to be able to do as much as I can on my own. I'd really like to fill some holes and put in some patch panels with an oxy/gas set up as well as get out some minor dings. I'm open to any ideas and directions to go. Can't wait to get involved on here! Thanks, Jason 
|
|
#3
06-11-2011, 04:26 PM
|
|||
|
|||
|
Hi Jason, In my opinion you have a headstart with wanting to work with gas welding. I do about 90% of my welding with gas. It is best for aluminium and I use it for steelwork as well. If the weld are done right it is possible to get great results with very little distortion.
Welcome to the site! David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
