|
|
|
#1
11-06-2011, 11:58 PM
|
|||
|
|||
Yo
Just making this post because it's required, I really rather just lurk but oh well.
I live in the rust belt so there is always some sheet metal that needs replaced. I read a sheet metal handbook but it was pretty basic so I am here to see what everyone is up to. I am just learning to weld with my new old Victor oxy/ace rig. I am thinking about making a sheet metal intake manifold, fender flares fixing some rusty cancer on my run of the mill import car and maybe a few other things. Oh and also debating on building a Locust 7 
|
|
#2
11-07-2011, 02:46 AM
|
|||
|
|||
|
Welcome to the site Biff
 Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
11-07-2011, 05:51 PM
|
|||
|
|||
|
Hello Biff, welcome to the site. I am sure you will enjoy being here and learn more if you join in.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
