|
|
|
#1
11-08-2011, 08:37 AM
|
|||
|
|||
eddie in NYC
hey friends, thanks for having me.
jumped into the welding "deep end" in 1980 while working a tig machine on SS sheet metal. it was from there that i started to pick up knowlage in the ancient arts, such as mig, stick, THEN, oxy-fuel welding. during the last two decades iv'e been employed by some of the bigger names in car and motorcycle fabrication. natural progression led me to an intense interest in shaping. hoping to help out here as much as i can while reaching out for advice on the real challenging stuff. hope to hear from you guys soon. cheers. Eddie.
__________________
eddie mcgarry 
|
|
#3
11-08-2011, 05:20 PM
|
|||
|
|||
|
Welcome to the forum Eddie
 Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
11-09-2011, 04:49 PM
|
|||
|
|||
|
Welcome to the site Eddie.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
