|
|
|
#1
02-10-2012, 04:36 PM
|
|||
|
|||
Hello from Oklahoma
I have a 49 Chevy I'm starting to work on, and I've found quite a few helpful threads here so far. I do computers for work, but I'm in school for machining.
I'm hoping to learn some new techniques and share some of what I already know.
__________________
Paul 
|
|
#2
02-10-2012, 05:04 PM
|
||||
|
||||
|
Mike, welcome and thanks for the introduction. Hope you enjoy the site and find it helpful. Thanks for joining us. Your machinist skill will be an asset as you build some tools and tooling.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#3
02-10-2012, 05:07 PM
|
|||
|
|||
|
Welcome to the site Mike
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
