|
|
|
#1
04-01-2012, 12:27 PM
|
|||
|
|||
Willys Aero Project
As an introduction I am working on a 1954 Willys Aero Eagle Custom, which has many reverse curves in its front and rear shape. I have the uniframe rails reinforced and have just started on patches for the rear end. I did make a complete rear valance panel that actually came out OK.
Located in Motown.
__________________
Les Lang 
|
|
#2
04-01-2012, 03:09 PM
|
|||
|
|||
|
Welcome to the madhouse mate
theres plenty of knowledge to be picked up on these boards and you may even be able to teach some of us a few things A wise man (not me for sure) once said there are main points to life 1/ The only stupid question is the one not asked 2/The day you stop learning is the day they put into the ground Cheers mate Troppo
__________________
" He who works with his hands is a laborer. He who works with his hands, and his head is a craftsman. He who works with his hands, and his head, and his heart, is An Artist. "- St. Francis of Assisi
|
|
#3
04-01-2012, 05:18 PM
|
|||
|
|||
|
HI Lang welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
