|
|
|
#1
02-03-2013, 06:34 AM
|
|||
|
|||
New guy taking the plunge
Hey guys and gals. Joe here from Wendell, NC. Been surfing through this site for the last couple days and have seen some pure art and artist here. The reason I came to this site was because I was conducting a Google search for car panel forming and ran across one of your member's project. It sparked my interest and so I looked at a few more of you guys' projects. Very talented people here.
I have serval classic cars that are beginning to become dilapidated and in need of sheet metal work. One in particlular is a 1957 Porsche 356 that was used as a race car, crashed, and left to rot away. Looking at panels for that era 356 is ok if you need the major parts, ie: fenders, hood, decklid, ect. But, this vehicle needs a little more love then that. Final thought for my introduction is this. Thanks to the owners and moderators of this site for operating a top notch place where like minded people can share ideas and experiences. Joe Guyer
__________________
Joe 
|
|
#3
02-03-2013, 10:18 AM
|
|||
|
|||
|
Welcome to All Metal Shaping Joe. Thanks for the great intro.
__________________
Nick M. Some more projects: http://www.facebook.com/iNVisionPrototypes https://www.instagram.com/invisionprototypes https://www.youtube.com/c/iNVisionPrototypes
|
|
#4
02-03-2013, 04:11 PM
|
|||
|
|||
|
HI Joe welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
