|
|
|
#1
02-02-2013, 04:00 PM
|
|||
|
|||
Hi from Strawberry Hill
Yes, my small locality really is called that.
I've been machining for several years, and I've just finished my Quorn. My thoughts are turning to the steel guitar I have on my project list, and top of the requirements for that is a bead roller. So I've landed here. How long either project will manage to fight off the demands of the rest of my lists, I have no clue, but after learning a great deal on the HSM forum, I'm looking forward to some time here with eagerness.
__________________
Richard 
|
|
#4
02-02-2013, 10:22 PM
|
|||
|
|||
|
HI Richard welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#5
02-03-2013, 08:44 PM
|
|||
|
|||
|
barry larson
Richard.....Looking at building the same thing....Have plans ? Bead roller in under constuction....Plans came from Beard 301 733 8271 us.. full size drawings round neck .032 steel.....i should start cuting materal in a week....rounded up some pattren materal this weekend........Best of luch with your project,,,,take a look at u tube National steel Guitar,,,,,,,,,,,,they have about 10 shorts on makeing them......Barry Larson AZ
__________________
Barry Larson
|
 |
|
|
Linear Mode
