|
|
|
#1
02-15-2016, 09:58 PM
|
|||
|
|||
Old newbie here
Hi all. I have been working on a late 60's muscle car and will have a few projects that will involve working with metal at some point. I am a complete DIY guy, hoping to never allow a shop work on my car. I was looking fo some how-to sites and somehow ended up here. I will be checking in from time to time but probably not too much before next Monday. I'm have back surgery on that day. I hope to learn a lot here
__________________
Thanks, Andy M 
|
|
#2
02-16-2016, 12:14 PM
|
||||
|
||||
|
Hello Andy and welcome to the forum.
Hope your surgery goes well.   Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
02-16-2016, 06:01 PM
|
|||
|
|||
|
Hi Andy welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
