|
|
|
#1
11-21-2010, 05:39 PM
|
|||
|
|||
My Intro....
Hello everyone! My name is Erik I live in Los Angeles, Ca. I’m into everything metal, especially sheet metal and of course equipment to work on such…. I grow up in a body shop because of my father; he worked as a body man longer then me being a live….. I’m very fortunate to have enquired quite a bit of equipment over the years partly due to my pops…. My current project a 36-3W ford that has been chopped, I have been working on her for a while now but hope to get her on the road by spring, not finished but on the road. I’m looking forward to jumping in, sharing and receiving info….
Thanx again Erik 
|
|
#2
11-21-2010, 05:43 PM
|
||||
|
||||
|
Erik, thanks for the introduction and welcome aboard. Hope you can get the three window on the road on schedule. Post some of your progress on the sheet metal work when you can. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#3
11-21-2010, 05:57 PM
|
|||
|
|||
|
Welcome to the site Erik, I am sure you will enjoy this site, they are a friendly lot on here.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
|
#5
11-21-2010, 08:01 PM
|
|||
|
|||
|
Thanx everyone for the warm welcome…….
I'm in Lawndale, 5min from LAX, right off the 405.
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
