|
|
|
#1
12-06-2012, 07:42 PM
|
||||
|
||||
And I thought the DMV was a challenge
Hi new guy here. When it comes to old school metal forming, now that I can work with. I hope I can contribute and pick up a few tricks.
I don't recall seeing how many "posts required" before posting a "for sale" add but I just left a retiring old timers shop that did aircraft, auto panels and copper flashing & gutters. Shop is full of ewheels, planishing hammer, shears, brakes, clecos, and all the stuff you would expect to do panel work. I told him I would help him out and I would look for a place to advertise for him. Am I in the right place? 
|
|
#2
12-06-2012, 08:13 PM
|
||||
|
||||
|
Welcome to AllMetalShaping Chuck. If you hang around a while, you'll understand why we have all the hoops you had to jump through.
Feel free to post your friends stuff in the individual classifieds. Make sure you include a general location, contact info, and prices.
__________________
Kerry Pinkerton
|
|
#3
12-06-2012, 08:14 PM
|
|||
|
|||
|
HI Chuck
Welcome to the forum Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#5
12-06-2012, 11:03 PM
|
|||
|
|||
|
Welcome to the forum from N. Illinois, Chuck.
__________________
Mark from Illinois
|
|
#7
12-07-2012, 08:58 PM
|
||||
|
||||
|
Thank you all for the welcome. I will be reading and learning before I start doing much in the way of posting. My background with sheet metal working is associated with former NASCAR Winston Cup cars. When I find time I will do an album to display some of my work. Untill then, here's a couple of shots of a 1987 Monte Carlo I did. The eWheel (forming front fender) is 1 of 4 that I home built using Ron Fornier plans 8 years ago.
Thank you, 86MonteRestorationA 004 (4).jpg klb8924 090.jpg Marcis Aero Coupe 027.jpg
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
