|
|
|
#1
02-20-2014, 04:00 AM
|
|||
|
|||
Hello from Sean , Glasshouse mountains, Australia
hello
I have been restoring and racing old dirtbikes for around 10 years now, and as part of that I,ve learnt to tig and gas weld, fabricate quite a few bits and pieces, roll cones for two stroke exhausts etc. so I have always been fascinated by metal work. I really admire some of the aluminium shaping work done by people on some of the older bikes/planes cars whatever, and I saw this site recommended, and was quite excited when I had a look as my knowledge on this area is pretty limited. Id like to learn some of the skills and tools needed for working aluminium as I have a ccm bike which is mostly metal(not plastic) and id like to craft a few bits and pieces . Well that's my story!
__________________
Sean Allanson 
|
 |
|
|
Linear Mode
