|
|
|
#1
03-25-2014, 05:21 PM
|
|||
|
|||
Hallo
Hi everyone, I'm Nielen
I have recently done a course in sheet metal shaping and enjoyed it very much and learned a lot. That's where I got word of this forum. I'm sure I'm going to get a lot more tips and tricks from the other members of this site. Hoping to build on my newly acquired skills and knowledge.
__________________
Nielen 
|
|
#3
03-25-2014, 10:42 PM
|
|||
|
|||
|
Hi Nielen welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
03-25-2014, 11:14 PM
|
|||
|
|||
|
Hi Nielen - great to see you made it on here!
I was impressed by the progress you made on the course and how quickly you got to grips with shaping! Looking forward to seeing your progress. Some of the best shapers in the world share their knowledge and experience here 
|
|
#6
03-26-2014, 01:50 AM
|
|||
|
|||
|
Welcome to the forum Nielen.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
|
#7
04-01-2014, 12:05 PM
|
||||
|
||||
|
Hello Nielen and welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer. Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
