|
|
|
#1
08-31-2014, 04:49 PM
|
|||
|
|||
Introduction... Hi
Hello,
Martin here, 40 something and spending far too much time in the garage (so she tells me). I restored a '71 Triumph GT6 about 10 years ago, and as most people do, I still tinker with it. Recently I discovered reshaping thin stainless sheet into exhaust heat shields and enjoyed it, then tried a small mock up section of wheel arch (fender) with reverse curve again in stainless and was ok. I then decided to make some stainless wing mirrors, but struggling, so I come here to seek the know how. Anyway, here I am and hope to learn. Martin
__________________
Martin Last edited by Martin F; 08-31-2014 at 05:06 PM. 
|
|
#2
08-31-2014, 05:08 PM
|
|||
|
|||
|
Hi Martin welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
