|
|
|
#1
10-28-2014, 10:55 AM
|
|||
|
|||
New guy to the forums.....
Great site I frequently end up ending up at when searching for answers beyond my skill level. I'm Retired USAF and have always loved metal fab; started out in automotive fixn up my first car. Texas Native so not a lotta rust under my belt, but I've managed to compile a decent inventory of tools of the trade over the years; just looks to tweak my skills. Look'n forward to absorbing the knowledge base here and hope to add to it..!
__________________
J. Higgs Abilene, TX 
|
|
#2
10-29-2014, 02:11 AM
|
|||
|
|||
|
Welcome to the forum, lots of information here, the good thing about this craft is that you don't need a lot of machines at least to get started most things can be done with a few hand tools.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
|
#3
10-29-2014, 11:08 AM
|
|||
|
|||
|
Hi J. welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
