|
|
|
#1
12-04-2015, 09:47 PM
|
|||
|
|||
Introduction
Hello all a friend told me about this site and that I should check it out and that it would be useful to help me in learning how to shape metal. I am currently working on a 70 Camaro and am planing on doing a lot of modifications to it and think I could learn a few things from this site. Thanks in advance.
__________________
Zach 
|
|
#2
12-05-2015, 01:15 PM
|
||||
|
||||
|
Hello Zach and welcome to the forum.
I'm just up the road in Willits. Stop by if your up this way.  Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
12-05-2015, 06:41 PM
|
|||
|
|||
|
Hi Zach welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
