|
|
|
#1
07-29-2015, 08:48 PM
|
|||
|
|||
New here
Hey guys my names Dennis, just signed up here and just starting to try to learn some metal shaping.....I have just started trying to make something for the first time, figured a motorcycle fender would be a good first project. I'm sure I will have loads of questions and hoping to learn as much as I can here.
__________________
Dennis 
|
|
#2
07-30-2015, 04:51 AM
|
|||
|
|||
|
Hi Dennis welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
08-04-2015, 05:29 PM
|
||||
|
||||
|
Hello Dennis and welcome to the site. Lets see some photos of your fender.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
