|
|
|
#1
09-01-2015, 07:18 AM
|
|||
|
|||
Another new one from Melbourne, Australia
Hi, joined (partially) over a year ago but got distracted with kid, life in general etc. Here as I'm keen to learn. Have '68 XT Falcon ute which was bought as a partial resto. The ute floor is very bad so i'm interested in learning about forming strengthening ribs in metal sheet, amongst many, many other things.
Have seen some amazing work on this forum already. Cheers Tommy Edit - looks like i did sign up properly back in feb 2014! Please disregard! (Mentioned the ute was a 67 back then but have since decoded the vin plate and learnt otherwise)
__________________
Tommy Last edited by trh510; 09-01-2015 at 07:22 AM. 
|
|
#2
09-01-2015, 12:02 PM
|
||||
|
||||
|
Hello Tommy and welcome to the forum.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
09-01-2015, 07:49 PM
|
|||
|
|||
|
Hi Tommy welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
