|
|
|
#1
10-21-2015, 08:09 AM
|
|||
|
|||
hello all
Hi all
My name is Ali and I have been playing with metal in most forms for 50yrs. From panel work to spinning to structural to all kinds of castings. The first reason (of many) for my interest in this site, is to find out more about the size of flat spots on curved anvils on typical English wheel setups. This seems like a good place to find out Thanks 
|
|
#2
10-22-2015, 10:42 AM
|
||||
|
||||
|
Hello Ali and welcome.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
10-24-2015, 07:42 PM
|
|||
|
|||
|
Hi Ali welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
