|
|
|
#1
12-31-2015, 11:40 AM
|
|||
|
|||
New to the Forum
Hello Everyone,
I am new here as I find myself needing some help with sheetmetal fabrication. I have welded big metal for years in my plowing business. I learned how to stick weld many years ago. Many late plowing nights fixing plow frames in the middle of a snow storm on old rusty metal. I just purchased a mig welder from Eastwood and my first project is to repair a quarter panel for a friend. I hope you all have some good advise. I look forward to learning more about sheetmetal fabrication. Thanks for having me. Mark Steffen
__________________
Mark Steffen 
|
|
#2
12-31-2015, 04:22 PM
|
||||
|
||||
|
Hello Mark and welcome to the forum.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
12-31-2015, 08:19 PM
|
|||
|
|||
|
Hi Mark welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
